SPZ SPA SPB SPC These four models are triangular with narrow V-type

Select the tape model is based on the power of the transmission tape to decide, there are a lot of knowledge.

Select the model selected model should be selected with the triangle tape to adapt, otherwise the triangle tape in the pulley groove

There will be abnormal circumstances, the use of triangular tape, it is best to bring the old to the agricultural sector to buy, to prevent the models do

Wrong.

Correct installation Before installation, if the center distance between the two axes is adjustable, the center distance should be shortened first, the tape

Installed and then adjust the center distance according to the requirements; if the center distance between the two axes is not adjustable, you can put a triangle with the first set

Into the wheel slot, and then turn another pulley, the triangle tape installed, with the same method will be a set of triangular tape are

install. Installation prohibited with tools hard pry, hard pull on the V-belt, to prevent the triangle tape elongation or too loose too tight phenomenon.

To prevent the trough to install the pulley, the center of the two pulleys must be aligned, otherwise it will cause the triangle tape

Side work, wear serious, reduce the use of triangular tape.

The elasticity of the elasticity of the triangular tape must be checked and adjusted so that it meets the requirements. The triangle is too loose

Easy to slip, but also increase the V-belt wear, or even can not transmit power; too tight, not only will make the triangle belt elongated deformation,

Easy to damage, but also cause the engine main bearing clutch bearing due to force is too large, and accelerated V-belt wear.

The correct check method is: hand in the middle of each tape, apply about 2 kg of vertical pressure, the amount of subsidence (20 -

30) mm is appropriate, inappropriate to be adjusted in time.

Old and new or two or more triangular tape need to be replaced, to use the provisions of the model of the triangle tape,

And require each group of triangular tape tightly consistent, not allowed to mix old or reduce the number of use, otherwise, the old and new V-belt force

Uneven, even the old triangle belt does not work, affect the power transmission and shorten the life of the V-belt.

Prevent the use of pollution to prevent the triangle with oil and muddy mud, to avoid contact with acid, alkali and other corrosive substances,

To prevent slippage and corrosion of the V-belt and early damage.

Day care machine and the user in the usual driving to master the correct operating essentials, in accordance with the instructions

Technical requirements, try to avoid fierce start and brakes: should also prevent frequent overload; equipment should be removed for a long time

Triangle tape is stored separately.